| Wheelhouse roof | ||||||
| Install two Solar panels | ||||||
| Plugs on all wiring to mast for quick disconnect | ||||||
| Cut wings on mast so it can laydown on roof | ||||||
| Install bracket for mast when down | ||||||
| Fender boards mounted | ||||||
| Passarell mounted | ||||||
| Alt mounting for GPS, Anammoter, and search light for low clearance | ||||||
| Life raft | ||||||
| Cutout in overhang for 16' vhf, alt to 4' | ||||||
| Install solar fans in hatches | ||||||
| Wheelhouse exterior | ||||||
| Mast step to roof | ||||||
| Sunscreen on windshield | ||||||
| Deck starting at bow | ||||||
| Replace rivits with pins to remove pulpit section bow rail | ||||||
| Install passerelle reciever at anchor pulpit | ||||||
| Install line holders in fwd lazaretts | ||||||
| Install 400' anchor chain, spare anchor in lazarette | ||||||
| Install small cleats on toe rail at each chalk | ||||||
| Supply jack lines running from fwd cleats back | ||||||
| Salt and fresh washdown fittings | ||||||
| Fabricate and install 'bunny bed' between rails | ||||||
| Fabricate bow rail height posts ( with and without mast) | ||||||
| Install Passerelle recievers port and starboard | ||||||
| Install deck access hatches over fuel tank fittings | ||||||
| Install mooring tape reel on bow or stern rail | ||||||
| Fwd Bilge | ||||||
| Install parallel macerator | ||||||
| Install platform for storage | ||||||
| Fwd stateroom | ||||||
| Install 12v outlet and fan | ||||||
| Install bus heater under bed | ||||||
| Midship Bilge | ||||||
| Relocate bilge pump to aft of compartment | ||||||
| Install hinges and air piston on stateroom floor hatches | ||||||
| Install vent line on water tank | ||||||
| Cockpit | ||||||
| Install rolling screen on bifold doorway | ||||||
| Install sreen/shade combo on rear window | ||||||
| Install 6 small cleats | ||||||
| Install rear windless, line feeds to engine room | ||||||
| Install recievers for grill | ||||||
| Install major cleats for towing | ||||||
| Supply snatch block for swim platform cleats | ||||||
| Cut rear transom door | ||||||
| Install SureShade | ||||||
| Add side and rear curtains to SureShade and mister line | ||||||
| Install epirp | ||||||
| Baths | ||||||
| Install built in hair dryers | ||||||
| Install dispensers in showers | ||||||
| Change cabinet door in master bath | ||||||
| Galley | ||||||
| Install Brew Express coffee maker | ||||||
| Change cabinet doors over cooktop | ||||||
| Fabricate and install wine glass rack | ||||||
| Fabricate and install spice rack | ||||||
| Rearrange glass cabinet shelving | ||||||
| Install shelving under sink | ||||||
| Rework storage under stairs for toaster oven | ||||||
| Underfloor - install rails for plastic storage tubs | ||||||
| Install hinges and air pistons on floor hatches | ||||||
| Main Saloon | ||||||
| Install velcroed screens on side windows | ||||||
| Remove bar and icemaker, longer settee and table | ||||||
| Install bus heater under settee | ||||||
| Install overhead rail length of cabin | ||||||
| Fabricate and install bookcase at windshield | ||||||
| Fabricate and install magazine rack | ||||||
| Crew cabin | ||||||
| Install second refrigerator/freezer | ||||||
| Convert double bed to single | ||||||
| Install wire rack shelving on starboard side behind mattress | ||||||
| Washer and Dryer orderd with boat | ||||||
| Helm | ||||||
| Install connecting plug for Cummin/zeus computer | ||||||
| Provide I-Pad mount with power supply | ||||||
| Install speed over water sensor | ||||||
| Install bow depth sounder | ||||||
| Install anchor rode counter | ||||||
| Add controls for aft windless | ||||||
| Electrical | ||||||
| Add A/B switch for cooktop on inverter power | ||||||
| Add A/B switch for hot water heater on inverter power | ||||||
| Move built in vac to inverter circuit | ||||||
| Install 220v/50cy battery charger with plug for and aft | ||||||
| Replace 4D house batteries with 8D | ||||||
| Replace 100 amp alt on port engine with 160 amp | ||||||
| Boat ordered with 3000w inverter | ||||||
| Wire in solar panels | ||||||
| Outlet on inverter in crew qt for washer and dryer | ||||||
| Engine room | ||||||
| Fabricate and install stand for tool box | ||||||
| Install second fresh water pump | ||||||
| Install sight glass on fuel tanks | ||||||
| Add second bilge pump in aft bilge | ||||||
| Install 12v water maker | ||||||
| Install mounts for spare prop behind port engine | ||||||
| Install hose reel | ||||||
| Repipe aft freshwater fill thru filter to tank | ||||||
| Add fitting on port fuel tank at crossover for alt feed to generator | ||||||
| Add petcocks on fuel filters | ||||||
| Fabricate a fitting for base of fuel tank for pumpout or transrfer | ||||||
| Add fitting on air horn tank for filling fenders, etc. | ||||||
| Add filter rack | ||||||
| Boat certified to EU standard and plaque installed | ||||||